Dee-zee DZ2044 User Manual

Before returning this product to the store of purchaseContact Dee Zee if you experience the following problems:    •MissingParts   •Installat

Place the running board on the angle braces. Adjust the angle braces as needed to insure that theholes can be drill through the board to attach it to

Drill 1/4" holes up through the board using the holes shown below.For the middle and rear location, drill through either the 1st and 3rd slot, or

Pressing the flap up against the wheel well, drill two 3/16" holes through the hole in the mud flapinto the sheet metal of the wheel well. Repea

Dee Zee Running Board Installation InstructionsCongratulations on your purchase of a quality Dee Zee product. Dee Zee isrecognized as having the highe

BD 2044WX2GSK-4117 FT.FP0300X4B 1988X2BRACKETB 81FXX6PN 87X18PN 70X18PN 72X54PN 71X36PN 97X18B 1984PX4B4570X4I1/4 X 1" RIBNECK 1/4 X 3/4" HE

WRENCH/RATCHET3/8", 7/16"TAPEMEASURETIN SNIPSCLAMP3/16" DRILL BIT1/4" DRILL BITPlace the rubber trim onto the back lip of the

Measure back from the front wheel well and mark the lower rocker panel at 18", 41" and 68".This will be the approximate location for th

Attach the rocker brackets [E] to the rocker panel with a ribneck carriage bolt [F],washer [H], and nut [I].Repeat this for each bracket location.5Onc

Drill a 3/16" hole through the slot in the back of brace into the bottom of the frame.Attach the channel brace to the frame using a sheet metal s

Attach the angle brace [K] to the bottom of the MIDDLE and REAR mounting bracketthrough the slot shown in the anglel brace using a hex head bolt [G],

Use a level to set the angle brace parallel to the ground. Clamp the frame brace [L] in place.Drill two 3/16" holes into the frame through the h