X1BASEX1X1X2B 2035LP/RPX1 LH / X1 RHD EBRACEENDCSHORT SIDECARGO CARRIERDZ 760084RSIDE STEP TUBE TALL SIDEA BX2B 2035LP/RPX1 LH / X1 RHB 2034LP/RPX1 LH
Using a 1/4" hex bit and drill, attach the end panels to the base use the self-drilling screw [M].Do not over tighten the screws. Repeat at all
DZ 760084R 11 of 11 1/16/2012
WRENCH/RATCHET10mmPLIERS1/4" NUT DRIVER BITOn the underside of the cargo carrier, slide the hitch tube [I] into the opening aligning the holesi
Attach the hitch tube to the carrier using the L-pins [J], washers [K], and cotter pins [L].2This step continued on the next page.DZ 760084R 3 of 11 1
Once the L-pins are in position insert the cotter pin into the hole in the L-pin.When the cotter pin has been inserted, using a pair of pliers, spread
Attach the braces [E] to the cargo carrier using four 6mm bolt [G] and four 6mm nuts [H].Make sure that braces [E] are being used in the step. Note t
Slide the tall panel [B] into the braces [E] previously installed.Make sure the the circular tabs are facing the inside of the cargo carrier when inst
Slide the short panel [C] into the braces [F] previously installed.Make sure the the circular tabs are facing the inside of the cargo carrier when ins
Slide the end panels [D] into the braces previously installed.Make sure the the circular tabs are facing the inside of the cargo carrier when installe
Insert the four pins [N] into the circular tabs to tie the panels together.8DZ 760084R 9 of 11 1/16/2012
Comments to this Manuals