Before returning this product to the store of purchaseContact Dee Zee if you experience the following problems: •MissingParts •Installat
Extend the top section until the spring button engages the second hole on the side. On the inside of the top section, pull up on the material arm.Exte
Once both sides have been extended, press the push button in the cross bar and pull it out. Insert the cross bar into the other side of the rack and e
After engaging the push button, push the two halves of the rack apart, until the other pushbutton engages. Do NOT use the rack with out both push b
To stow the Invis-a-rack, depress the push button that was engaged in the previous step and pullthe two haves of the rack towards each other. Disengag
Slide the cross bar back until the push button engages in the first hole. Depress the push button and bring the material arm down.PUSH BUTTON WILL ENG
Depress the push button to lower the remaining part of the rack.Then depress the push button in safety stop to complete the stowing of the rack. PUSH
To see a video showing the rack being put up, please use the QR code below. *Review & assure understanding of all load, handling, operating limita
IR-HOUSING-ASSEMLX2IR-HOUSING-ASSEMRX2THERE IS NO BUNGEE BOX IN THE 5 FT. APPLICATION6 FT.MOUNTING HOOK SECTION CAPEDCBUNGEE BOXINVIS-A-RACK INSTALLAT
WRENCHUTILITY KNIFE OR SCISSORS 9/16"7/32" ALLEN WRENCH OR SOCKETRATCHETPeel a portion of the paper back from the adhesive on the foam gaske
If your application includes bungee boxes, they will need to be assembled. With the lid held almost perpendicular to the base, align the hook on the b
Set the first assembly [A] on the bed of the truck on the driver's side near the cab. This step is shown with the small bungee box for the 6&apos
Thread one of the 3/8" nuts [H] onto the 3/8" bolt [G], then thread the bolt part wayinto the hole on the hold down clamp [D]. There will b
Use the images below to locate the hold down clamps for each truck bed length.The end hold down clamps should be For applications with the bungee box,
Tighten the bolts using a 7/32" allen wrench/socket. Start with the bolt closest to the cab and workyour way to the bolt at other end of the bed
Repeat these installation steps for the other side of the bed. To use the Invis-a-rack, pull up on the top sectionusing the cut out provided.89There i
Comments to this Manuals