Measure back from the front wheel well and mark the lower rocker panel at 18", 41" and 68".
This will be the approximate location for the rocker panel bracket [E].
Make sure there is nothing on the bottom of the frame at these location that would obstruct the
channel / angle brace from being installed in the later steps. If there is an obstruction, move the rocker
panel bracket to the front/rear as needed.
3
4
The bottom of the mounting bracket should be 1" below the bottom of the pinch weld.
Mark the hole location in the vertical long leg of the mounting bracket .
Remove the bracket and drill a 1/4" hole through the pinch weld.
Repeat this for each bracket location.
POINTING TOWARDS
THE FRAME
DZ 2044 3 OF 10 8/14/2012
Comments to this Manuals