Before returning this product to the store of purchaseContact Dee Zee if you experience the following problems: •MissingParts •Installat
Slide two square head bolts [K] into the channels on the underside of the running board.Line the bolts in the running board up with the slots in the b
Slide the board to the desired location from front to rear. A tape measure may be used to insurethe board is centered between the wheel wells. Slide
Dee Zee Running Board Installation InstructionsCongratulations on your purchase of a quality Dee Zee product. Dee Zee isrecognized as having the highe
DZ 16201DZ 16202DZ 16203X2PN 685X1PN 1094X4DRIVER SIDE FRONT BRACEDRIVER SIDE REAR BRACEB 2179PX1B 2180PX1PASSENGER SIDE FRONT BRACEPASSENGER SIDE FRE
WRENCH/RATCHET10mm, 13mmTAPEMEASUREM6 ALLENLocate the mounting locations as shown below. The driver's side is shown.TOOLS REQUIRED1DZ 16253 2 OF
There are 7 rubber plugs along the edge of the rocker panel.Starting from the front tire, remove the 2nd and 5th rubber plug.Thread a nutsert [C] on t
Using a 13 wrench and a 6mm allen socket, tighten the nutsert into place. This is done by holding the6mm allen wrench/socket stationary and turning t
Put the threaded plate into the hole where the 2nd rubber plug was removed.Once the threaded plate is in the hole, attach the rear mounting hole in th
Thread a nutsert [C] on to the nutsert tool [B], and insert the nutsert into the hole shown below.Repeat the process fron Step 4 to install and torque
Put the threaded plate into the hole where the 5th rubber plug was removed.Once the threaded plate is in the hole, attach the rear mounting hole in th
Comments to this Manuals