Before returning this product to the store of purchaseContact Dee Zee if you experience the following problems: •MissingParts •Installat
Using a 8mm wrench/socket, remove the two factory bolts shown below from the wheel well.Do NOT discard the bolts, as they will be used to attach the m
Align the running board with the cab board. 8Once the side box board is align with the cab board, clamp the running board to the brackets.Using the sl
Attach the running board to the angle brace using the 1/4" x 1" ribneck carriage bolt [M], 1/4" flat washer [J], and 1/4" hex nut
Dee Zee Running Board Installation InstructionsCongratulations on your purchase of a quality Dee Zee product. Dee Zee isrecognized as having the highe
BD 3375 LP/RP1LH/1RHGSK-414 FTMUDFLAP1 LH / 1 RHB 1848PX2BRACKETBRACKETBRACKETBRACKETE F G HDee Zee Brite Tread Running Board Installation Instruction
WRENCH/RATCHET 7/16", 9/16"TAPE8mmMEASURETIN SNIPS 1/4" DRILL BITM8 ALLENLocate the front sub-box support as shown below. Loosely att
Insert the support brace [D] into the opening at the front box support and attach to the braceusing the 3/8" bolt [O], two 3/8" washers [P],
Locate the rear sub-box support as shown below. Loosely attach the rear driver brace [G]the bottom of the sub-box support using the M12 bolt [R] and
Place a 1/4" washer [J] and 1/4" nut [L] on one end of the u-nut [I]. Insert the u-nut in to the bracehole as shown below. Bring the end o
Attach the angle brace[T] to the main braces using the 1/4" x 1 1/4" bolt [S], 1/4" washer [J] and1/4" nut [L].When installed the
Using tin snips, cut the gasket provided into 2 equal pieces (approximately 24").Place bulb-seal gasket [B] onto the back lip of the running boar
Comments to this Manuals