Dee-zee DZ503397 User Manual download pdf

BULL BAR

2011 FORD SUPER DUTY F250/F350

Page 1 of 2 6/18/10 (DP)

PARTS LIST:

Bull Bar

Driver/Left Mounting Bracket

Passenger/Right Mounting Bracket

10-1.50mm x 30mm Hex Bolts

10mm x 27mm OD x 3mm Flat Washers

10mm Nylon Lock Nuts

PROCEDURE:

1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ

INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. ASSISTANCE IS

RECOMMENDED.

2. NOTE: It may be necessary to remove/relocate front license plate and license plate bracket. It

is not required, but strongly recommended. If local/state law requires a license plate, license

plate relocation kit is available.

3. Start installation at the driver side, front of the vehicle. Remove the (2) driver side bumper

mount bolts, (Figure 1). WARNING! Do not loosen or remove passenger and driver side

bumper mounting bolts at the same time or bumper will move out of alignment or may fall off of

the vehicle. Only remove the bumper bolts from one side and install one Mounting Bracket at a

time.

4. Place Mounting Bracket onto vehicle and line up the (2) slots with the (2) holes for the bumper

bolts. NOTE: Leave about 1/8” clearance between the Mounting Bracket and the bumper.

Secure the Mounting Bracket to the vehicle using the factory bumper bolts, (Figure 2). Fully

tighten these bolts at this time.

5. Once the driver side Mounting Bracket is fully tightened, repeat Steps 3 - 4 for passenger side

Mounting Bracket installation.

6. With assistance, position the Bull Bar onto the outside of the Mounting Brackets. NOTE: Move

Mounting Brackets in or out as required to line up with the mounting tabs on the Bull Bar.

Attach the Bull Bar to the Mounting Brackets using the included (4) 10mm x 30mm Hex Bolts,

(8) 10mm Flat Washers and (4) 10mm Nylon Lock Nuts, (Figure 2). Snug but do not tighten

hardware at this time.

7. Level and adjust the Bull Bar as desired and tighten all hardware at this time.

8. Do periodic inspections to the installation to make sure that all hardware is secure and tight.

To protect your investment, wax this product after installing. Regular waxing is recommended to

add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives

that could damage the finish.

For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish.

Mild soap may be used also to clean the Bull Bar.

For gloss black finishes: Mild soap may be used to clean the Bull Bar.

Passenger Side

Mounting Bracket

Driver Side

Mounting Bracket

1 2

BULL BAR 2

Summary of Contents

Page 1

BULL BAR 2011 FORD SUPER DUTY F250/F350 Page 1 of 2 6/18/10 (DP) PARTS LIST: 1 Bull Bar 1

Page 2 - BULL BAR

BULL BAR 2011 FORD SUPER DUTY F250/F350 Page 2 of 2 6/18/10 (DP) Installation Complete Driver Sid

Related models: DZ503399

Comments to this Manuals

No comments

Dee-zee DZ503397 User Manual

Browse online or download User Manual for For the car Dee-zee DZ503397. Dee Zee DZ503397 User Manual [es]

Summary of Contents

Related models: DZ503399

Comments to this Manuals

Related products and manuals for For the car Dee-zee DZ503397