Before returning this product to the store of purchaseContact Dee Zee if you experience the following problems: •MissingParts •Installat
Once the board is straight with the cab board, clamp the board to the angle brace anddrill 1/4" holes up through the board using the 1st and 3rd
Pressing the flap up against the wheel well opening, drill a 3/16" holes through the mudflap andthe sheet metal of the wheel well. Secure the fl
Dee Zee Running Board Installation InstructionsCongratulations on your purchase of a quality Dee Zee product. Dee Zee isrecognized as having the highe
BD 1360 L/R1 LH / 1 RHGSK-156 FT.MUDFLAP1 LH / 1 RHB 1648LPX2B 1648RPX2B 865X2B 885X2PN 72X 361/4" FLAT WASHERE F G HLEFT BRACKET1/4" HEX NU
WRENCH/RATCHET3/8", 7/16", TAPE13mm, 18mmMEASURETIN SNIPS3/16" DRILL BITPHILLIPS SCREWDRIVERUsing tin snips, cut a piece of rubber tr
Locate the rear sub-box support as shown below. Remove the factory bolt holding the frame tothe bottom of the sub-box support using an 18mm socket an
Locate the rear sub-box support as shown below. Remove the factory bolt holding the frame tothe bottom of the sub-box support using an 18mm socket an
Attach the 9" angle brace [F] to the front brace, and the 13.5" angle brace [G] to the rear brace using the 1/4" x 1" hex head bol
Place the side box board on the angle braces. Align the side box board with the cab board.The board will need to be rotated into position.Adjust the
Attach the mud flap to the end of the running board using the 1/4" x 1" hex head bolt [L], the 1/4" flat washer [H], and the 1/4"
Comments to this Manuals