Before returning this product to the store of purchaseContact Dee Zee if you experience the following problems: •MissingParts •Installat
The threaded plate on mounting bracket [B] will be attaching to the hole shown below.Pull down on the plastic cladding and insert the end of the threa
Insert the 7/32" Allen through the hole drilled in Step 7 and into the head of the button head bolt.Pull down on the mounting bracket to put the
Using the 3/8" button head bolt [M], 3/8" washer [N], and offset threaded plate [J], thread the bolt into the platethrough the slot in the r
Using the 8mm bolt [H] and 8mm nut [L], attach the rear brace to the mounting bracket.Do NOT completely tighten at this time.Move the brace and the th
Once the rear inner bolt is tightened, tighten the bolts connecting the rear brace to the mounting bracket using a 13mm socket/wrench.The plastic pane
Once the panel has been trimmed, reinstall it using the 10mm sockets and the bolts thatwere removed earlier.Reinstall the clips that attach the claddi
Slide two square head bolts [K] into the channels on the underside of the running board.Line the bolts in the running board up with the slots in the b
Slide the board to the desired location from front to rear. A tape measure may be used to insurethe board is centered between the wheel wells. Slide
Dee Zee Running Board Installation InstructionsCongratulations on your purchase of a quality Dee Zee product. Dee Zee isrecognized as having the highe
BRACKETBRACKETDZ 16201DZ 16202DZ 16203X2B 2189LPX1B 2189RPX1DRIVER SIDE FRONT BRACEPASSENGER SIDE REAR BRACEB 2190LPX1B 2190RPX1DRIVER SIDE REAR BRACE
WRENCH/RATCHET10mm, 13mmTAPE 1/4" DRILL BIT7/32" ALLENTIN SNIPSMEASUREUsing the 8mm bolt [H] and threaded plate [I], thread the bolt into
Insert the threaded plate into the outer slot at the front mounting location. 2DZ 16223 3 OF 15 8/9/2013
Using the 8mm bolt [H] and threaded plate [I], thread the bolt into the platethrough the slot shown below in the front driver side brace [D].Once the
Align the brace so that it is perpendicular to the vehicle. Pull down on the brace to put tension onthe threaded plates and tighten with a 13mm socke
To attach the rear mounting bracket, you will need to drill a 1/4" hole through the plastic cladding.The 1/4" hole will be located 11/16&quo
Once the hole has been drilled, release the 2 clips on either side of the cladding cut out.Using a 10mm socket, remove the panel. One of the bolts is
Comments to this Manuals