Before returning this product to the store of purchaseContact Dee Zee if you experience the following problems: •MissingParts •Installat
Pressing the flap up against the wheel well, drill two 3/16" holes through the hole in the mud flapinto the sheet metal of the wheel well. The f
Dee Zee Running Board Installation InstructionsCongratulations on your purchase of a quality Dee Zee product. Dee Zee isrecognized as having the highe
BD 2045LP/RP1 LH / 1 RHGSK-416.25 FT.FP0300X2B 1988X4BRACKETB 81FXX4PN 87X12PN 70X8PN 72X 28I1/4 X 1" RIBNECK 1/4 X 3/4" HEXHEAD BOLTJCARRIA
WRENCH/RATCHET3/8", 7/16"TAPEMEASURETIN SNIPS3/16" DRILL BIT1/4" DRILL BITPlace the rubber trim onto the back lip of the runni
Measure back from the front wheel well and mark the lower rocker panel at 18"and 30".This will be the approximate location for the rocker pa
Attach the rocker brackets [E] to the rocker panel with a ribneck carriage bolt [F],washer [H], and nut [I].Repeat this for each bracket location.5Onc
Drill a 3/16" hole through the slot in the back of brace into the bottom of the frame.Attach the channel brace to the frame using a sheet metal s
Place the running board on the angle braces. Adjust the board to make sure the flap is up against the inner portion of the wheel well.Then adjust the
Drill 1/4" holes up through the board using the holes shown below.Repeat this step for each bracket location.Attach the running board to the angl
Comments to this Manuals