Before returning this product to the store of purchaseContact Dee Zee if you experience the following problems: •MissingParts •Installat
8Locate the existing holes in the vehicle shown below. These are the hole locations for the front and rear support brackets.Trouvez les trous existant
9Place the driver front support bracket up to the hole location in the vehicle. Slide the threaded plate into the existing hole. Now attach the bot
Drill with a 3/16” drillbit11Using the pictures below as a guide, first drill two 3/16” holes through the mudflap on the running board and the sheet m
X1Rubber Trim PieceMudflapRubber TrimPieceOptional Installation of Rubber Trim Piece on Mudflaps:Place the rubber trim piece around the outer edge of
Dee Zee Running Board Installation InstructionsCongratulations on your purchase of a quality Dee Zee product. Dee Zee is recognized as having the hig
Dee Zee Elite Running Board Installation InstructionDZ E39922(2002 - Current) Dodge Ram Regular Cab PickupBBulb-Seal GasketX2AEliteRunning Board10.5 f
1Place bulb-seal gasket (B) onto the backlip of elite running board (A) and trim the bulb-seal gasket (B) so that it is flushwith the ends of elite r
Attach the plastic endcap (D) and stainless steel endcap (C) to the rear of elite running board (A)as shown below using 1/4 x 3/4” carriage head bolts
3Locate and remove the plastic plugs/or vinyl tape on the inside of the vehicle rocker panel at approximately 10 ½” and 55 ½” from the front wheel wel
5Assemble each of the braces using a 3/8 x 1 1/4” hex head bolt (R), 5/16” flat washer (O), and threaded plate (S) as shownbelow. The threaded plate s
Place a 1/4 x 3/4” carriage head bolt (K) into the welded brackets on the bottom of the running board. Place the driver front bracket (E) and driver r
Place the driver side running board assembly up to the vehicle rocker panel. Slide the threaded plates on the front and rear brackets into the holes
Comments to this Manuals