Before returning this product to the store of purchaseContact Dee Zee if you experience the following problems: •MissingParts •Installat
Align the bolt in the channels on the bottom of the running board with the slots in the braces andinsert the bolts into the slots. Loosely attach the
Pressing the flap up against the wheel well opening, drill three 1/8" holes through the mudflap andthe sheet metal of the wheel well. Secure the
Dee Zee Running Board Installation InstructionsCongratulations on your purchase of a quality Dee Zee product. Dee Zee isrecognized as having the highe
BD 27944BD 27344P1 LH / 1 RHGSK-4117 FT.MXFLSL/R2 LH / 2 RHB 1989X2BRACKETB 81FXX6PN 87X6PN 70X10PN 72X38PN 71X28PN 97BX14PN 86AX12PN 140X161/4"
WRENCH/RATCHET3/8", 7/16"TAPEMEASURETIN SNIPSCLAMP3/16" DRILL BIT1/4" DRILL BITPlace the rubber trim onto the back lip of the
Measure back from the front wheel well and mark the lower rocker panel at 18", 41" and 68".This will be the approximate location for th
Attach the rocker brackets [E] to the rocker panel with a ribneck carriage bolt [F],washer [H], and nut [I].Repeat this for each bracket location.5Onc
Drill a 3/16" hole through the slot in the back of brace into the bottom of the frame.Attach the channel brace to the frame using a sheet metal s
Attach the angle brace [M] to the bottom of the MIDDLE and REAR mounting bracketthrough the slot shown in the anglel brace using a hex head bolt [G],
Use a level to set the angle brace parallel to the ground. Clamp the frame brace [N] in place.Drill two 3/16" holes into the frame through the h
Comments to this Manuals