Before returning this product to the store of purchaseContact Dee Zee if you experience the following problems: •MissingParts •Installat
AOSlide fx mudflap (Q) onto the front end of fx running board (A).Note: You may have to trim the inner part of the fx mudflap (Q)to fit the vehicle c
AQNow drill a 1/8“ hole through the bottom of fx mudflap (Q) and fx running board (A) as shown below.Forez maintenant un 1/8“ trou par le bas du (Q) d
Dee Zee Running Board Installation InstructionsCongratulations on your purchase of a quality Dee Zee product. Dee Zee is recognized as having the hig
Dee Zee FX Running Board Installation Instruction(2002 - Current) Dodge Ram Quad Cab PickupBTo o l s Re q u ir e d :Outils Nécessaires:Bulb-Seal Gask
FX 31023 / FX 31323 / FX 31923/ FX 39023: Align the 1/4 x 3/4“ slotted hex head bolts (I) with the 1st and 3rd slots in angle braces (D) at the locati
7/16“ Wrenchor Socket5Using the pictures below as a guide, locate the body mount bolts on the vehicle and remove them using 18mm / 19mm socket and rat
8Place the front, middle, and rear body mount assemblies up to the front and rear body mounts as shown below. Tighten into place using 18mm / 19mm w
LKAttach rocker panel brackets (F) to the vehicle rocker panel at the locations shown below using 1/4 x 1“ ribneck carriage head bolts (H), 1/4“ flat
812LevelVise-GripDAVehicle Rocker PanelMake sure that running board (A) is level and then clamp the short and tall body mount brackets to angle braces
137/16“ Wrenchor SocketDrill witha 1/4“ drillbitDAVehicle Rocker PanelRear of Running BoardFront of Running BoardTall and ShortBody MountBracketBodyMo
Comments to this Manuals