Before returning this product to the store of purchaseContact Dee Zee if you experience the following problems: •MissingParts •Installat
Using a 13mm wrench/socket, tighten the bolts that attach the brace to the vehicle. Tighten the top bolt first. It mat still be necessary to push up
Once the board location has been set, tighten the nuts holding the board to the braces usinga 13mm socket/wrench. Make sure all bolts are tightened.
*** TUBES SOLD SEPARATELYX2X3PN 685X2PN 686X12X3PN 525X18PN 835X6PN 526X24PN 1093X12PN 72BX12PN 71BX12SUPPORT BRACKETBRACE KITX12FROM TUBEB 2173LPX3T
WRENCH/RATCHET13mm, 15mm, 7/16"Install the 8mm nutsert [E] as shown below.The passenger's side is shown. The front of the vehicle is to the
Use the nutsert set tool [D] to crimp the nutserts in the holes.Hold the nut on the set tool with a 15mm wrench. Tighten the bolt in the set tool wit
The vehicle cab style will determine which brackets are to be used at the different mounting locations. Please refer to the cab drawings for bracket
CREW CABWhen the mount braces is put up to the vehicle mounting location, the threaded plate must go into the large slot above the nutserts previously
Thread 2 of the 8mm x 25mm bolts through the slots in the braces into the nutserts.Only engage the bolts a few threads into the nutserts. Then pushin
Attach the support brace to the main brace using two of the 8mm x 20 mm bolts [L] and two of the 8mmflange nut [H].Do not tighten at this time. Repea
Once the brackets are in place, set the tube on the braces and adjust as necessary front to back.Look under the tube to determine which sets of slots
Dee Zee Running Board Installation InstructionsCongratulations on your purchase of a quality Dee Zee product. Dee Zee isrecognized as having the highe
Set the tube back on the brackets and slide the U-nuts in the tube slots so that they alignwith the mounting slots in the braces. Repeat at all mount
*** BOARD SOLD SEPARATELYX2B 1828LPX3PN 685X2PN 686X12B 1828RPX3PN 525X18PN 835X6PN 526X24PN 1093X12PN 72BX12PN 71BX12SUPPORT BRACKETB 2173LPX3PN 527
WRENCH/RATCHET13mm, 15mm, 7/16"Install the 8mm nutsert [E] as shown below.The passenger's side is shown. The front of the vehicle is to the
Use the nutsert set tool [D] to crimp the nutserts in the holes.Hold the nut on the set tool with a 15mm wrench. Tighten the bolt in the set tool wit
The vehicle cab style will determine which brackets are to be used at the different mounting locations. Please refer to the cab drawings for bracket
CREW CABWhen the brace is put up to the vehicle mounting location, the threaded plate must go into the large slot above the nutserts previously instal
Thread 2 of the 8mm x 25mm bolts through the slots in the braces into the nutserts.Only engage the bolts a few threads into the nutserts. Then pushin
Attach the support brace to the main brace using two of the 8mm x 20 mm bolts [L] and two of the 8mmflange nut [H].Do not tighten at this time. Repea
Comments to this Manuals